Diagonal Short Layer

- Create a center part.

- Create basic sections 5 and 6. All the hair above theparietal ridge should be isolated.

- Apply a 1/2 inch diagonal subsection parallel to the hairline in front of the ear. .

- Using the fine teeth of the comb, position the hair T to the section.

- Comb and hold the hair at 90°, T to the section. Hold with medium and even tension.

- Use primary scissors position & cut to the desired length.

- As you cut, your scissors and fingers holding the hair

are parallel to the parting/subsection.

- Pick up some of the guide and then the next 1/2 inch diagonal subsection, parallel to the first. Hold at 90° and cut to the guide.

-Continue creating 1/2 to 1 inch diagonal subsections until you reach the center part. Notice that the hair at the

bottom is past center.

-Cross check the entire right side by combing in the

opposite diagonal subsections.

- Repeat steps for the left side.

- Drop sections 5 and 6.

- Apply a safety section to the front perimeter.

- Using primary scissors position, cut the safety section to the desired length.