1) Create a center part from thefront hairline to the nape.

In the back right at the nape, create a horizontal part from the center part to the middle of the ear.Clip the hair above it up and away.

2) Divide the back right subsectionhorizontally to create blockings.

Comb the hair, place end papers and wrap the rod to the scalp.

Repeat in left side

3) Create another horizontal part across the back of the head, just above the previous section. The diameter of the rod will determine the size of the section. At the right ear, take a vertical blocking, the diameter of the rod.

4) Comb the hair and hold it at a low (approximately 45 degree) elevation while wrapping the rod. Apply a single end paper and fold it lengthwise. the hair should be placed in the fold of the end paper. Slide the end paper down to cover the ends.

5) Hold the rod vertically with the fastener on top. Begin wrapping as close to the open end of the rod as possible upward.Rotate the rod 1-1/2 to 2 circular rotations, then continue to spiral the hair on the rod. Secure the rod in place.

6) Working from right to left, take vertical blockings, apply end

papers and spiral the hair onto therods as usual.

7)Continue working up the head in this manner until you reach the parietal ridge. There is no need to place picks on spiral wraps.

8)Start in the center section at the front hairline and work toward the point of distribution. The first rod is often wrapped traditionally, based on the length of hair in this area, in order to provide maximum curl.

9) Place the rod beneath the middle of the strand. Holding the rod with your dominant hand, wind the rod to the scalp, holding and rotating the hair ends as the rod rotates. Then, secure the band.

10) Apply a single end paper, folded lengthwise, to the hair ends. Wrap this rod in the opposite direction of the first rod. The second rod sits on top of the first. Pick the two rods together. Continue in this manner, workingthrough the center top section.

11) Move to the right front section and visualize two side-by side rows of rods.

12)Continue in this manner

through this section, placing picks as you work.

13) Repeat this process in the left front section.

14) apply solution

15) Process, test, rinse, blot andneutralize.

Spiral/piggyback (combined) Permanent Wave Wrap