To be continued...

14 Thermal Iron Curl Styling

Forming Figure 6 Curls (for short to mid-length hair)

✔️Holding the curl at the correct elevation, move the iron away from the scalp.

✔️Use comb to move hair along the barrel toward the handle, and then rotate iron.

✔️Place the comb under the curl, by the scalp, to protect the scalp.

✔️Rotate the iron, opening and closing it so the hair rotatesfreely into a curl.

✔️Continue rotating until full length of strand is curled around the barrel.

✔️Remove curl by gently clicking iron to right & moving hair w/comb off of barrel.

Forming Figure 8 Curls (for long hair)

✔️Holding the hair at the correct elevation, move the

iron away from the scalp to about mid-shaft.

✔️Use the comb to move the hair along the barrel

toward your hand, near the handle, and then rotate the iron.

Note: At this point, the creation of a figure 8 curl is verysimilar to the creation of a figure 6 curl.

✔️Then draw the strand to the opposite side of the curl and pull it over the topof the barrel (use your fingers or comb if necessary).

✔️Place the comb under the curl, by the scalp, to protect the scalp.

✔️Rotate hair around tong and barrel, clicking so hair rotates freely into a curl.

✔️Continue rotating until all the hair in the strand is curled around the barrel.

✔️Remove the curl from the iron by gently clicking the iron and moving the hair with the comb off the barrel.

✔️Optional: Clip the curl in place for a firmer curl.

✔️When the hair cools, remove the clips (if you used them) and brush the hair through to finish, applying hair spray or other product as necessary.